A sturdy wall- or ceiling-mounted bracket for a 25 mm curtain rod.

The open C-shaped holder allows the curtain rod to be placed into the bracket without having to slide the rod through the holder. The bracket features a 5 mm thick ring wall and a triangular reinforcement for added stiffness.

The bracket can be mounted using one central screw, either to the ceiling or to a wall, depending on the desired installation.

FITS

Rod diameter: 25 mm

Ring inner diameter: 25.0 mm

Mouth opening: 19 mm

Rod centre: 44.5 mm from the mounting surface

Mounting: Wall or ceiling

Screw: One central screw

DIMENSIONS

55 × 62 × 15 mm

Ring wall thickness: 5 mm

Screw hole: 6.4 mm at the mounting surface, tapering to 8.8 mm

PRINT SETTINGS

Layer height: 0.16 mm

Walls: 3

Infill: 8%+

Supports: Not normally required

Material: PLA or PETG

The model is designed to be printed flat on the build plate. The geometry does not normally require supports, but supports can be enabled if preferred.

For a stronger print, increasing the number of walls is recommended.

IMPORTANT

The bracket is designed for a 25 mm curtain rod and can be mounted to either a wall or ceiling. Because 3D printers and materials can produce slight dimensional differences, print one bracket first and test the fit with your actual rod before printing multiple brackets.

Use suitable screws and wall/ceiling anchors for your mounting surface and the weight of your curtain.

LICENSE

Free to print, share and remix for personal use.

Commercial use is not permitted.